KEYPAD: battery operated, wireless alphanumeric keypad designed for configuring/programming and operating AACTVision security systems.
The KEYPAD consists of a liquid-crystal (LCD) display with two 16-character lines, multi-function push buttons, a panic alarm button, a built-in sounder, and Videofied S2View®1 spread spectrum, interactive, encrypted wireless circuitry for secure two-way communication with the control panel.
The LCD display provides easy to read messages and turns off after 30 seconds of no keypad activity, to conserve battery power. Pressing any button (except the panic alarm button) restores the display. Backlighting is controlled automatically, based on lighting in the keypad location.
The keypad allows complete alphanumeric programming of all system settings/parameters in AACTVision security systems.
S2View® spread spectrum, Videofied, interactive, encrypted wireless circuitry effectively makes the keypad a mobile programmer that can be used anywhere within the installation site during system programming. Easy to understand display text guides you through programming, prompting you for simple yes/no or data entry responses. The left and right arrow buttons cycle through menus or values until the desired choice is displayed. Alphabetical entries are done using the 0 - 9 buttons and can be in lowercase, uppercase, or a combination of both. Complete punctuation symbols are also available for data entries such as website/IP addresses and component location naming.
Arming/disarming the system with the keypad is easy. For example, the 1 and 2 buttons just below the display can be programmed to arm a specific part of the premises just by pressing the button once, and then it will prompt you for your code. The house outline button just below the display can be used to arm the perimeter of the premises in the same manner.
The keypad is typically installed near entry/exit doors to allow system users enough time to arm and exit the premises, and to enter and disarm the system before time delays expire.
When the system is armed, the built-in sounder emits a series of exit delay beeps to remind the user to exit before the beeps stop. Upon entering the armed premises, the built-in sounder emits entry delay beeps to remind the user to disarm the system to avoid an alarm. A dual tamper function provides detection for both keypad cover and wall tamper.
The keypad is powered by four lithium batteries that can last four years or more, depending on the amount of keypad activity.
The keypad transmits a check-in signal every eight minutes that includes its unique identification code, along with the tamper condition, serial number, date of manufacture, software revision and battery status.
1: S2View®—Spread Spectrum, Videofied, Interactive, AES Encrypted Wireless technology provides optimum signal integrity and security. [specifications] |
